Install
Inflate the Tub:Locate the valve on the Bath Tub. Attach the floor pump and inflate the tub until it reaches the recommended pressure of 8-10 PSI. Ensure the valve is securely closed after inflation.
INSTALLATION & USAGE GUIDELINES
Preparation
Unpack the Components:Remove the Bath Tub,Protective Top Lid,Hand pump,and Carry Bag from the box. Laythem out on a flat, clean surface.
Inflate the Protective Top Lid
Similarly, attach the hand pump to the Protective Top Lid’s valve and inflate until firm. Once inflated, secure the valve with the safety cap.
Set UpNear a Water Source
Position the inflated tub in the desired location, preferably close to a water source. Ensure it's on a stable, flat surface and within 1-3 feet of where you plan to place the chiller, if using.
Filling the tub
Connect to Water Chiller (If Using): If using a water chiller, connect the inlet and outlet pipes from
the chiller to the Plunge Bath.Ensure a seamless water flow between
the bath and the chiller, signified by the green for inlet and red for outlet.
Fill with Water
Fill the PLUNGE MAGIC inflatable Tub with cold water using a hose. Fill until the water is roughly 15 cm (6 inches) below the underside of the top ring. The tub should not be more than½full to prevent over flow when entering.
Use the Lid
Always use the lid to protect the plunge bath from dirt and debris.
After Use
Draining and Storage: After use, drain the tub using the outlet drainage system provided. Clean the tub as necessary, deflate, fold, and store it along with other components in the Carry Bag for your next use.
Important Tips
- Always check for any sharp objects or debris on the surface before laying down the tub to avoid punctures.
- Regularly inspect the tub and lid for any leaks or damage before use.
- Always monitor the water temperature and maintain it at a safe level for cold therapy.
- Never leave children unattended near or in the Plunge Bath.